User's Guide

Using the Projector on a Network 93
Using the EasyMP Network Projection
Software
Once you’ve set up your projector and computer for network
projection, see the EasyMP Network Projection Operation Guide for
instructions on the following EasyMP features (PowerLite
85+/825+/826W+ only):
■ Starting EasyMP Network Projection
■ Projecting over the network (content over IP)
■ Multi-screen projection
■ Using Presentation mode
■ Connecting to a projector on a different subnet
Removing the Wireless 802.11a/b/g
Module
Follow these steps to remove the module from your projector
(PowerLite 85+/825+/826W+ only).
1. If you’re running EasyMP Network Projection, click
Disconnect
on the control bar.
2. Check the access light to make sure it isn’t flashing.
Click
Disconnect
caution
Never remove the module
while its indicator light is
green or when projecting
wirelessly. You may damage
the module.
Access light