User'sGuide Multimedia Projector 822p/83c
Table Of Contents
- Front Matter
- Contents
- Welcome
- Setting Up the Projector
- Projecting
- Using the Remote Control
- Fine-tuning the Projector
- Maintenance and Transportation
- Solving Problems
- Monitoring the Projector Over a Network
- Technical Specifications
- Notices
- Index
Maintenance and Transportation 73
3. Use the screwdriver included with the replacement lamp or a #2
Phillips-head screwdriver to loosen the screw holding the lamp
cover (the lamp cover is located on top of the projector).
4. Slide the cover out, then lift it off.
5. Use the screwdriver to loosen the two screws holding the lamp in
place. (You can’t remove the screws.)
6. Hold the lamp as shown and pull it straight out.
note
The lamp(s) in this
p
roduct contain mercury.
Please consult your state and
local regulations regarding
disposal or recycling. Do not
p
ut in the trash.
Don’t remove
these screws