User's Guide

Fine-Tuning the Projector 117
■ Operation
Use this menu to enable the following functions:
Direct Power On to have the projector start when the power
cable is connected (without pressing the
Ppower button).
Sleep Mode to have the projector turn off automatically if it is
idle (and no signal is received) for the amount of time you select
as the
Sleep Mode Timer (1 to 30 minutes).
Lens Cover Timer to have the projector turn off automatically
after 30 minutes when the A/V Mute slide is closed.
High Altitude Mode to increase cooling at high altitudes. Enable
this setting when you are using the projector above 4900 ft (1500
m).
■ Standby Mode
Select Communication On to enable the following features, even
when the projector is in standby mode (the power light is orange):
■ monitoring of the projector over a network (PowerLite
84+/85+/825+/826W+ only)
■ audio output from a connected microphone (you must also
set the Standby Microphone setting as described below)
■ video output to a connected external monitor (see page 53 for
more information) (PowerLite 84+/85+/825+/826W+ only)
■ Standby Microphone
When the Standby Mode is set to Communication On, you can
set Standby Microphone to
On. This allows you to use a
microphone connected to the projector even in standby mode,
when Power On Protect is off.
■ Plug-in Power
Select On when you are connecting a condenser microphone.
note
If Direct Power On is
enabled, the power cable is
connected, and a power
outage occurs, the projector
will start when the power is
restored.
Do not use the projector at
altitudes above 7500 ft
(2,286 m).