Product Information Guide

EPSON PowerLite 600p/800p/810p Projectors
6 - EPSON PowerLite 600p/800p/810p Projectors 8/01
Adjusting the Image Shape
If the projected image isn’t square or has a “keystone” shape,
do one or more of the following:
❏ If your image looks like or , you’ve placed the
projector off to one side of the screen, at an angle. Move it
directly in front of the center of the screen, facing the screen
squarely. If you still can’t get a square image, press the left or
right
Keystone
button on the projector’s control panel.
❏ If your image looks like or , press the top or
bottom
Keystone
button to correct the shape of the image.
After correction, your image will be slightly smaller.
You can also perform electronic keystone correction using the
projector’s Setting menu.
Switching Between Picture Sources
If your projector is connected to more than one computer
and/or video source, you can use the buttons on the control
panel (or remote control) to switch between the different
sources.
On the control panel, press the
Computer/YCbCr
button to
switch between computer sources and component video. Press
the
Video
button to switch between standard (composite)
video and S-Video sources.
On the remote control:
❏ Press the
Comp2/YCbCr
button to select a computer or
component video source connected to the Computer 2/
Component Video port on the projector.
❏ Press the
Comp1
button to select a computer connected to
the DVI
Computer 1
port on the projector.
❏ Press the Video
button to select a standard composite video
source.
❏ Press the
S-Video
button to select an S-Video source.
After you select a source, the screen goes dark for a moment
before the image appears.
Projector Status Lights
The lights on top of the projector indicate the projector’s
operating status.
Light Status Description and action
Does not
come on
Make sure the power cord is securely
connected at both the power outlet and
projector.
Green The projector is operating normally.
Flashing
green
The projector is warming up. Wait for the
image to appear.
Orange The projector is in sleep mode. You can
unplug it to turn it off, or press the Power
button to turn it on.
Flashing
orange
The projector is cooling down. Wait for the
light to stop flashing before unplugging the
projector or turning it back on.
Flashing red Power is cut off because of an internal
problem. Disconnect the power cord and
contact EPSON for help.
Red The lamp is burned out and must be replaced.
Flashing
orange
The lamp is almost burned out. This is a good
time to replace it.
Flashing red There is a problem with the lamp, power
supply, fan, or circuit. If necessary, replace the
lamp.
lamp light
temperature
light
power light