Product Information Guide

EPSON PowerLite 7850p Projector
12 - EPSON PowerLite 7850p Projector 6/03
Configuring the Connection
You must configure both the projector and your network card
settings to project wirelessly.
You can configure the projector for either of the following
modes:
Ad Hoc mode: Lets you connect just one PC or laptop at a
time; you need the EPSON 802.11b card and a computer
with a wireless network card.
Access Point mode: Lets multiple users access the projector at
the same time, or trade off control of the projector; you need
the EPSON 802.11b card, a wireless access point, and one or
more computers with wireless network cards.
1. On the EasyMP Network Screen, make sure the Config
button in the lower right corner is highlighted. Then press
Enter on the remote control.
You see a screen similar to the following:
2. Use the pointer button on the remote control to select
either
Easy connect mode (Ad Hoc mode) or Access
Point mode. Then press Enter.
3. Use the pointer button to highlight the
Advanced
button next to the mode you selected, and press
Enter.
You see one of these screens:
4. Select the appropriate settings for your mode.
Use the pointer button on the remote control to
highlight a text box, then press
Enter. The outline of the
box turns green to indicate you’re in input mode. Tilt the
pointer button up to select individual letters in
alphabetical order, or down to select letters in reverse order.
Then tilt the pointer button right to move to the next
character position. When done entering a new setting, press
Enter.
To enter numbers, press the Num button on the remote
control. The button lights up to indicate that the numeric
keypad is active. Press the
Num button again to exit
numeric keypad mode. When done entering the setting,
press
Enter.
Ad Hoc
mode
Access
Point
mode