Product Information Guide

Epson PowerLite 76c Projector
6 - Epson PowerLite 76c Projector 9/05
Turning Off the Projector
When you’ve finished using the projector, follow the
recommended procedure to shut it down.
Note:
When the projector has not received any input signals for 30
minutes, it automatically turns off the lamp and enters “sleep
mode.” This conserves electricity, cools the projector, and extends the
life of the lamp. If you are done using the projector, unplug the
power cord. If you want to start projecting again, plug it in and
press the P
Power button. You can turn sleep mode on or off
through the Extended menu.
1. If you’re using a computer, shut it down first; otherwise you
may not be able to see your computer’s display to shut it
down properly.
2. To turn off the projector, press the P
Power button on the
projector or remote control.
You see this confirmation
message: (If you don’t want
to turn it off, press any other
button or wait a few seconds
until it disappears.)
3. Press the P
Power button again. The projector beeps
twice, the lamp is turned off, and the power light turns
orange.
Note:
With Epson’s exclusive Instant Off
technology there’s no cool-
down period, so you can pack up and go immediately after
turning off the projector.
If you want to turn the projector on again, press the
P
Power button.
4. Press up on the blue foot release lever and lower the
projector to retract the front adjustable foot, as shown.
5. Replace the lens cap and unplug the power cord.
6. Turn off and disconnect any equipment plugged into the
projector.
Caution:
To avoid damaging the projector or lamp, never unplug the
power cord when the power light is green or flashing orange.
7. If you won’t be using the projector for awhile, store it in the
soft case that came with it or in a protective case.
Selecting the Image Source
You can connect the projector to multiple video sources
simultaneously. Then use the buttons on the projector or
remote control to switch between them:
Comp
Press this button to move through the following options:
Computer (Auto), Computer (RGB), and Computer
(
Component Video).
S-Video
Press to select S-Video.
Video
Press to select Video.
You can also press the Source Search button on the remote
control or projector until the correct image is projected.
After you select a source, the screen goes dark for a moment
before the image appears. The name of the source appears
briefly on the screen.
Adjusting the Image
The following sections describe how to adjust the image once it
is displayed.
Adjusting the Height of the Image
If the image is too low, you can raise it by extending the
projector’s front foot.
1. Stand behind the projector. Press the foot release buttons
and lift the front of the projector. This unlocks the foot.
Foot