User's Manual

Presenting from a Memory Card 63
Before you start, make sure you are set up to access the card in your
computer’s PCMCIA slot or card reader. Be sure to use the transfer
process described below to ensure that the scenario plays properly:
1. From the Scenario Option menu, choose
Send Scenario. You
see a drive selection window:
2. Choose the drive where your card is located, then click
OK.
3. Click
OK again to confirm. Your scenario is transferred to the
card.
Once the scenario is transferred, you see this message about your
scenario’s autorun setting:
The autorun setting means that the scenario will start playing
whenever the projector is turned on (with the memory card in the
projector).
4. Do one of the following:
■ If you don’t want the scenario to run automatically, click
Cancel
. Skip to step 8 to remove the card and insert it in the
projector.
■ If you want it to run automatically, click OK and continue
with the following instructions.
note
You have to save the
scenario on your computer’s
hard drive before
transferring it. Don’t use
Windows to copy the
scenario to your memory
card, or it may not play
properly.
Select your memory
card drive