User's Manual

36 Presenting Through a Wireless Network

6. If your access point assigns IP addresses automatically, turn on

DHCP. Otherwise, turn off DHCP and enter the following

information manually:

■ IP address: Type in the IP address you want to assign to the

projector. It must be formatted like other addresses on the

network; usually the first three numbers (XXX.XXX.XXX)

match the access point’s IP address.

■ Subnet mask: For example: 255.255.255.000, but depends

on how your network is set up.

■ Gateway address: Enter the IP address that was assigned to

the access point when it was set up.

7. If a higher level of data-transmission security is desired, enter a

WEP Key as provided by your network or IT administrator.

8. If you want to create a password for remote access to the

projector, type it in the box next to

Password for WEB control

and press

Enter.

9. If you want to set up a security keyword so that only people who

are in the same room as the projector can access it, turn

Projector

keyword

on. Then when you want to connect to the projector, it

displays a randomized four-digit number or “keyword” on the

screen. When prompted by NS Connection, you can enter the

keyword on your computer to connect (see page 43).

10. If you want to monitor the projector using HP OpenView,

™

you’ll need to enter at least one trap IP addresses. See Chapter 7

for details on monitoring the projector.

11. When done making these settings, highlight the

OK button at the

top of the screen (you can either use the arrow buttons on the

remote control or press

ESC to highlight it), then press Enter.

Highlight the

OK button again and press Enter to return to the

main EasyMP Network Screen.

note

If you don’t know your

ateway or access point

address, see page 41.

note

For specific details about

your network, please consult

your network administrator.