User's Manual

Presenting Through a Wireless Network 35
Make sure Access point mode is selected, as shown. If not,
use the arrow buttons on the remote control to highlight the
checkbox next to
Access point mode, then press Enter
to select it.
3. Use the arrow buttons to highlight
Advanced (next to Access
point mode
), then press Enter to select it.
You see this screen:
4. Make sure the projector has a unique name, so you can identify it
when connecting to it from your computer.
If you need to rename it, highlight the
Clear button next to
Projector name, then press Enter to clear the text box. Then
highlight the text box and press
Enter. Use the up and down
arrows to select individual characters, and use the right arrow to
move to the next character position. When done typing the new
name, press
Enter.
5. To enable your computer to find the projector on the network,
you need to enter the ESSID (or SSID) identifier of your access
point. Highlight
ESSID and then press Enter. Then enter the
name of your access point in the text box; use the name that was
assigned to the access point when it was set up. Note that the
ESSID is case-sensitive (if it was typed in upper-case when the
access point was set up, you must enter it the same way in the
projector).
note
If you want to enter a blank
space, use the space character
that comes before the capital
letter A.