Product Information Guide

EPSON PowerLite 735c Projector
2/03 EPSON PowerLite 735c Projector - 5
If you’re using a laptop with Macintosh OS X:
You may need to set up your system to display on the
projector screen as well as the LCD screen. Follow these steps:
1. From the Apple menu, select
System Preferences, then
select
Displays.
2. Make sure the
VGA Display dialog box is selected.
3. Click the
Arrange tab.
4. Make sure the
Mirror Displays checkbox is selected.
Adjusting the Image
Once you see your image, you may need to make certain
adjustments:
❏ To focus or zoom the image, see below.
❏ If the image is too high or too low, see “Adjusting the
Height of Your Image” to the right.
❏ If the image isn’t square, see “Adjusting the Image Shape”
to the right.
❏ If the computer image displays incorrectly, see page 6.
Focusing and Zooming Your Image
Use the tab to rotate the focus ring to sharpen the image.
Use the tab to rotate the zoom ring and reduce or enlarge the
image.
You can also change the image size by moving the projector
closer to or farther away from the screen. You can use the
E-Zoom + or – buttons on the remote control to zoom in or
out on a portion of the image.
Adjusting the Height of Your Image
If the image is too low, you can raise it by extending the
projector’s feet.
1. Stand behind the projector. Push the foot release levers
on either side and lift the front of the projector. This
unlocks the feet.
Caution: Do not hold the projector by the lens; this can
damage it.
2. Once the image is positioned where you want it, release the
levers to lock the feet in position.
3. To fine-tune the height of the image, rotate the thumb
wheels attached to the projector’s feet.
If the image is no longer square after raising it, see the next
section.
Adjusting the Image Shape
If the projected image isn’t square or has a “keystone” shape,
do the following:
❏ If your image looks like or , you’ve placed the
projector off to one side of the screen, at an angle. Move it
directly in front of the center of the screen, facing the
screen squarely.
❏ If your image looks like or , press the
left or
right
side of the projector’s Keystone button to correct the
shape of the image. After correction, your image will be
slightly smaller.
Select the
VGA Display
dialog box
Make sure
Mirror Displays
is checked
Focus ring
Zoom ring
Use the Keystone
button to correct
distortion