Product Information Guide

EPSON PowerLite 735c Projector
4 - EPSON PowerLite 735c Projector 2/03
If a projected image fails to appear, see “What To Do If You
See a Blank Screen” below for help.
Starting EasyMP
1. Select EasyMP as the source by pressing the
Source button
on the projector or the
Comp/EasyMP button on the
remote control.
2. Insert either the EPSON 802.11b card (for wireless
presentations) or a memory card (for computer-free
presentations) into the projector’s card slot. (If you do not
insert a card, you see a screen prompting you to do so.)
For detailed instructions on running your EasyMP
presentation, see “Projecting Wirelessly in Ad Hoc Mode”
on page 7 or “Presenting from a Memory Card” on page 8.
What To Do If You See a Blank Screen
If you see a blank screen or a blue screen with the message
No Signal after turning on your computer or video source, try
the following:
❏ Make sure the cables are connected correctly.
❏ Make sure the power light is green and not flashing and the
lens cover is off.
❏ Try restarting your computer.
❏ Press the
Source button on top of the projector or the
Comp/EasyMP or Video/S-Video button on the remote
control to select the correct source. (Allow a few seconds for
the projector to sync up after pressing the button.)
If you’re using a PC laptop:
❏ Hold down the Fn key and press the function key that lets
you display on an external monitor. It may have an icon
such as or it may be labeled
CRT/LCD. Allow a few
seconds for the projector to sync up after pressing it. Check
your laptop’s manual or online help for details.
On most systems, the or
CRT/LCD key lets you
toggle between the LCD screen and the projector, or
display on both at the same time.
❏ Depending on your computer’s video card, you might need
to use the Display utility in the Windows
®
Control Panel to
make sure that both the LCD screen and external monitor
port are enabled. See your computer’s documentation or
online help for details.
If you’re using a laptop with Macintosh
®
OS 9.x:
You may need to set up your system to display on the
projector screen as well as the LCD screen. Follow these steps:
1. From the Apple menu, select
Control Panels, then click
Monitors or Monitors and Sound.
2. Click the
Arrange icon.
3. Drag one monitor icon on top of the other.
If the Arrange option isn’t available, you may need to select
one of the Simulscan resolution settings:
1. Click the
Monitor icon if necessary.
2. Select a
Simulscan resolution as shown. (Allow a few
seconds for the projector to sync up after making the
selection.)
Click here
Drag one monitor
icon on top of the
other
Click here
Select a
Simulscan
resolution