Quick Start Guide

1
Connect the power cord to your projector and plug
the other end into an electrical outlet.
2
Remove the lens cover.
3
Press the red Power button. The power light
flashes green, and then stays on.
4
Turn on or restart your laptop. (Windows
®
only: If you
see this Add New Hardware screen, click Cancel.)
S
T
A
R
T
H
E
R
E
Turn over
Turn on your equipment
Connect the projector
to your laptop
Power cord Computer cable
Follow these instructions to connect the projector
to your laptop. To connect other devices, such as
a VCR or desktop PC, see your User’s Guide.
EPSON
®
PowerLite
®
720c/730c
Quick Setup
Lens cover
Caution: Before unplugging
the projector...
To shut the projector down properly:
1. Press the red Power button twice.
Let the projector cool while the
power light flashes orange
(about 45 seconds).
2. Once the light stops flashing and
stays on, it’s safe to unplug
the projector.
Never unplug the projector when
the power light is green or
flashing orange.
For most setups, you’ll need just these two cables:
Power light
1
Make sure your projector and laptop are turned off.
2
Connect one end of the computer cable to the
Computer/Component Video port on the projector.
3
Connect the other end to your laptop’s video or monitor port.
If you can’t connect the cable to your PowerBook,
®
you may need
to use an adapter. See your User’s Guide for instructions.