Product Information Guide

EPSON Powerlite 51c/71c
12/01 EPSON Powerlite 51c/71c - 7
Adjusting the Image Size
You can adjust your image size using the
Wide/Tele
button on
the projector or zoom into a portion of the image using the
E-Zoom
button on the remote control.
Using the Wide/Tele Button
To enlarge or reduce your image size in small increments, use
the
Wide/Tele
button on the projector. Press the
T
side of the
button to reduce the image size, or the
W
side of the
Wide/
Tele
button to enlarge the image to full size.
Note:
You can always move the projector closer to or farther from the
screen to adjust the image size.
Using the E-Zoom Button
If you want to zoom in on a portion of the image, use the
E-Zoom
and
Enter
buttons on the remote control. Press the
+
side of the
E-Zoom
button to zoom into your image in small
increments. Press the
–
side to zoom out.
To position the zoomed image on the screen, press the top,
bottom, left, or right side of the
Enter
button on the remote
control. (Press
Esc
to return your image to its original size and
turn off E-Zoom.)
Adjusting the Image Height
If your image is too low, you can raise it by extending the
projector’s feet.
1. Stand behind the projector. Pull up the blue foot release
levers and lift the front of the projector. This unlocks the
feet.
2. Raise or lower the front of the projector as necessary.
Caution:
To avoid damaging the lens, do not lift the projector by the lens.
3. Once the image is positioned where you want it, release the
levers to lock the feet into position.
4. To fine-tune the height,
rotate the feet clockwise to
raise the projector and
counterclockwise to lower it.
Adjusting the Image
Shape
If the projected image isn’t square or has a “keystone” shape,
do one or more of the following:
❏ If your image looks like or , you’ve placed the
projector off to one side of the screen, at an angle. Move it
directly in front of the center of the screen, facing the screen
squarely.
❏ If your image looks like or , press the
+
or
–
side of
the
Keystone
button to correct the shape of the image. After
correction, your image will be slightly smaller.
Wide/Tele button
W
W
T
T
Enlarge
Reduce
Zoom in
Zoom out
+
–
E-Zoom button Enter button
top
rightleft
bottom