User's Manual

56 Fine-Tuning Your Projector
Creating Your Own Startup Screen
You can transfer any image on your computer to the projector,
and then use it as the screen displayed when the projector is not
receiving a signal. You can also set it to be displayed when you
press the
A/V Mute button on the remote, or as a startup
screen. The image can be a company logo, slogan, photograph,
or any other image you want to use.
Capturing the Image
You start by displaying the image you want to use on the
projector. You can use an image from either a computer or
video source such as a VCR or digital camera. Then follow these
steps to capture the image and transfer it to the projector:
1. Press the
Menu button. You see the main menu listing,
with the Video menu highlighted.
2. Press the bottom edge of the
Enter button (or tilt it down)
to highlight the
User’s Logo menu.
3. Press
Enter to select this feature. You see the message
shown at the left.
4. Select
Yes and press Enter. A selection box displays over
the image.
5. Use the
Enter button on the remote control to select the
area of the image you want to use. Once you have selected
the entire area, press Enter
.
6. When you see the message “Do you use this image?” select
Yes
and press
Enter
. If you want to change the area
selected, select
No
and repeat step 5. You see the message
shown at the left.
7. Use the
Enter
button on the remote control to select a
zoom rate (display size), and then press
Enter
.
8. When the message “Do you save this user logo?” appears,
select
Yes and press Enter.