User's Manual

66 Solving Problems
The power light is flashing orange and you can’t
turn on the projector.
The lamp is cooling down. Wait until the light stops flashing
and then press the
Power
button to turn on the projector.
The power light doesn’t come on.
Press the
Power
button to turn off the projector, check that the
power cable is connected securely at both ends, then press the
Power
button again to turn the projector on.
Projector Status and Warning Lights
Light Status Description and action
orange The projector is in sleep mode. You can unplug it or press the
Power
button to turn it on.
flashing green The projector is warming up. Wait for the image to appear.
green The projector is operating normally.
flashing orange The projector is cooling down. You can’t turn the projector on or
unplug it when the light is flashing.
red Power is cut off because of an internal problem. Contact EPSON
for help.
red The lamp is almost burned out. This is a good time to replace it.
See Chapter 4 for instructions.
flashing orange The lamp is burned out. Replace the lamp, following the
instructions in Chapter 4.
flashing red There is a problem with the lamp, power supply, fuse, or circuit.
Contact EPSON for help.
flashing orange The projector is too hot. Turn it off and let it cool before using it.
red The projector has turned off automatically because it has
overheated. Let it cool for a few minutes, then turn it back on.
Make sure nothing is blocking the vents on the front and top of
the projector. If it continues to overheat, you may need to change
the air filter. See Chapter 4 for instructions.
flashing red There is a problem with the cooling fan or temperature sensor.
Contact EPSON for help.