User's Guide
Table Of Contents
- Front Matter
- Contents
- Welcome
- Displaying and Adjusting the Image
- Using the Remote Control
- Connecting to Computers, Cameras, and Other Equipment
- Setting Up Network Projection
- Using Quick Wireless Connection
- Configuring Basic Settings
- Configuring the Connection
- Using Wireless Security Options
- Using the EasyMP Software
- Removing the Wireless 802.11a/b/g Module
- Connecting to a Wired Network
- Using Projector E-mail Alerts
- Using SNMP to Monitor the Projector
- Connecting With Windows Vista
- Fine-Tuning the Projector
- Maintaining the Projector
- Solving Problems
- Projector Installation
- Technical Specifications
- Notices
- Index
Setting Up Network Projection 89
Removing the Wireless 802.11a/b/g
Module
Follow these steps to remove the module from your projector.
1. If you’re running NS Connection, click
Disconnect on the
control bar.
2. Check the access light to make sure it isn’t flashing.
3. Turn off the projector and unplug it.
4. Turn the projector over. Unscrew the cover plate, then remove it.
5. Pull the module off of the projector.
6. Replace the cover plate and secure it with the screw.
Click
Disconnect
caution
Never remove the module
while the indicator light is
green or when projecting
wirelessly. You may damage
the module or lose data.