User's Guide
Table Of Contents
- Front Matter
- Contents
- Welcome
- Displaying and Adjusting the Image
- Using the Remote Control
- Connecting to Computers, Cameras, and Other Equipment
- Setting Up Network Projection
- Using Quick Wireless Connection
- Configuring Basic Settings
- Configuring the Connection
- Using Wireless Security Options
- Using the EasyMP Software
- Removing the Wireless 802.11a/b/g Module
- Connecting to a Wired Network
- Using Projector E-mail Alerts
- Using SNMP to Monitor the Projector
- Connecting With Windows Vista
- Fine-Tuning the Projector
- Maintaining the Projector
- Solving Problems
- Projector Installation
- Technical Specifications
- Notices
- Index
74 Setting Up Network Projection
10. Click the AirPort icon on the menu bar at the top of the
Macintosh desktop. You see the AirPort status menu:
11. Check to make sure AirPort is turned on.
12. Select the name of your AirPort network.
Making a WPS (Wi-Fi Protected Setup)
Connection
If you are using a WPS-compatible access point, you can configure the
settings for the connection between the projector and the access point
from the projector’s Configuration menu using one of these methods:
■ Push Button Method
Press both the
Enter button on the projector and the button on
the access point to make the SSID and security settings. This
method is recommended when the projector and access point are
close together.
■ PIN Code Method
With the PIN code method, you enter an 8-digit code from the
computer to enable the SSID and security settings. The
connection between the computer and the access point must have
already been established. (For connection instructions, refer to the
manual provided with the access point.) This method lets you
make the settings without having to press any buttons on the
projector, and is recommended when the projector is mounted on
the ceiling.