User's Guide
Table Of Contents
- Front Matter
- Contents
- Welcome
- Displaying and Adjusting the Image
- Using the Remote Control
- Connecting to Computers, Cameras, and Other Equipment
- Setting Up Network Projection
- Using Quick Wireless Connection
- Configuring Basic Settings
- Configuring the Connection
- Using Wireless Security Options
- Using the EasyMP Software
- Removing the Wireless 802.11a/b/g Module
- Connecting to a Wired Network
- Using Projector E-mail Alerts
- Using SNMP to Monitor the Projector
- Connecting With Windows Vista
- Fine-Tuning the Projector
- Maintaining the Projector
- Solving Problems
- Projector Installation
- Technical Specifications
- Notices
- Index
64 Setting Up Network Projection
Using Access Point Mode
To use Access Point (infrastructure) mode, first adjust your projector
and wireless access point or AirPort base station settings as described
in this section.
Configuring the Projector
1. Press the Menu button, then choose Network and press Enter.
2. Choose
Network Configuration and press Enter.
3. Choose
Wireless LAN and press Enter. You see this screen:
4. Make sure
Advanced is selected for the Connection mode. If
not, use the buttons on the remote control to highlight
Advanced, then press Enter to select it.
5. If your network is using 802.11a, use the buttons on the
remote control to highlight
802.11a, then press Enter to select it.
6. To enable your computer to find the projector on the network,
you need to enter the SSID name of your access point or the name
of your AirPort network in the
SSID text box. (The name of your
AirPort network may be different from that of your AirPort base
station; select your base station in the AirPort Admin utility and
click
Configure to check the name of your network.)