User's Guide
Table Of Contents
- Front Matter
- Contents
- Welcome
- Displaying and Adjusting the Image
- Using the Remote Control
- Connecting to Computers, Cameras, and Other Equipment
- Setting Up Network Projection
- Using Quick Wireless Connection
- Configuring Basic Settings
- Configuring the Connection
- Using Wireless Security Options
- Using the EasyMP Software
- Removing the Wireless 802.11a/b/g Module
- Connecting to a Wired Network
- Using Projector E-mail Alerts
- Using SNMP to Monitor the Projector
- Connecting With Windows Vista
- Fine-Tuning the Projector
- Maintaining the Projector
- Solving Problems
- Projector Installation
- Technical Specifications
- Notices
- Index
Setting Up Network Projection 59
the option and press Enter. When you’re done, highlight Finish
and press
Enter.
Note that the SSID is case-sensitive (if you enter the name in
uppercase on the projector, you must type it the same way on the
computer connecting to the projector).
7. If you want to prevent the SSID from being displayed on the
standby screen, set the
SSID Display option to Off.
8. To prevent the IP address from appearing on the standby screen,
set the
IP Address Display setting to Off.
9. When you’re done making these settings, highlight the
Return
button at the top of the screen, then press
Enter. Choose Setup
Complete
and press Enter, then choose Yes and press Enter to
save your settings.
Now you’re ready to set up your computer to project wirelessly. Go to
“Configuring the Network Settings for Windows” on page 60, or
“Setting Up Your Mac for Ad Hoc Mode” on page 62.