User's Guide
Table Of Contents
- Front Matter
- Contents
- Welcome
- Displaying and Adjusting the Image
- Using the Remote Control
- Connecting to Computers, Cameras, and Other Equipment
- Setting Up Network Projection
- Using Quick Wireless Connection
- Configuring Basic Settings
- Configuring the Connection
- Using Wireless Security Options
- Using the EasyMP Software
- Removing the Wireless 802.11a/b/g Module
- Connecting to a Wired Network
- Using Projector E-mail Alerts
- Using SNMP to Monitor the Projector
- Connecting With Windows Vista
- Fine-Tuning the Projector
- Maintaining the Projector
- Solving Problems
- Projector Installation
- Technical Specifications
- Notices
- Index
53
4l
Setting Up Network
Projection
This chapter tells you how to prepare to send images to your
projector through a wireless or wired network.
Using Quick Wireless Connection or EMP NS Connection, you can
project images shown on your computer screen—including text,
graphics, and video—directly to your audience. See the EasyMP
Operation Guide for information on features and use.
If you have Windows Vista, you can also use the Network Projector
feature to communicate with your network-connected projector.
You’ll find instructions in this chapter on:
■ Using Quick Wireless Connection
■ Configuring projector and network settings
■ Using wireless security options
■ Removing the wireless 802.11a/b/g module
■ Connecting the projector to a wired LAN
■ Sending e-mail alerts and monitoring the projector
■ Using Windows Vista Network Projector
Before starting, make sure you’ve installed the wireless module, as
described on the Quick Setup sheet, or the optional Ethernet unit
(see page 90). Then follow the steps in this chapter to use Quick
Wireless Connection (Windows only) or configure your projector and
network. Finally, see the EasyMP Operation Guide for instructions on
installing the EMP NS Connection software. The EasyMP Operation
Guide also contains instructions on using the software to project over
the network.