User's Guide
Table Of Contents
- Front Matter
- Contents
- Welcome
- Displaying and Adjusting the Image
- Using the Remote Control
- Connecting to Computers, Cameras, and Other Equipment
- Setting Up Network Projection
- Using Quick Wireless Connection
- Configuring Basic Settings
- Configuring the Connection
- Using Wireless Security Options
- Using the EasyMP Software
- Removing the Wireless 802.11a/b/g Module
- Connecting to a Wired Network
- Using Projector E-mail Alerts
- Using SNMP to Monitor the Projector
- Connecting With Windows Vista
- Fine-Tuning the Projector
- Maintaining the Projector
- Solving Problems
- Projector Installation
- Technical Specifications
- Notices
- Index
44 Connecting to Computers, Cameras, and Other Equipment
Connecting to Video Equipment
You can connect several video sources to the projector at the same
time. Before starting, look at your video equipment to determine its
available video output connections:
■ If your video player has a yellow RCA-style video output
connector, see “Connecting a Composite Video Source” on
page 45.
■ If your video player has an S-video connector, see “Connecting an
S-Video Source” on page 46.
■ If your video player has a component video port (three connectors
labeled either Y/Cb/Cr or Y/Pb/Pr), see “Connecting a
Component Video Source” on page 47.
■ If your video player has an RGB video port (either a single
connector for a VGA-style monitor cable or three connectors
labeled R/G/B), see “Connecting an RGB Video Source” on
page 48.
After connecting video cables, you may also want to connect an audio
cable to play sound through the projector; see page 50.
RCA connector
(composite video)
S-video
connector
VGA connector
(RGB video)