User's Guide
Table Of Contents
- Front Matter
- Contents
- Welcome
- Displaying and Adjusting the Image
- Using the Remote Control
- Connecting to Computers, Cameras, and Other Equipment
- Setting Up Network Projection
- Using Quick Wireless Connection
- Configuring Basic Settings
- Configuring the Connection
- Using Wireless Security Options
- Using the EasyMP Software
- Removing the Wireless 802.11a/b/g Module
- Connecting to a Wired Network
- Using Projector E-mail Alerts
- Using SNMP to Monitor the Projector
- Connecting With Windows Vista
- Fine-Tuning the Projector
- Maintaining the Projector
- Solving Problems
- Projector Installation
- Technical Specifications
- Notices
- Index
24 Displaying and Adjusting the Image
Using Keystone Correction
To adjust your image when it is wider on the top or bottom, do the
following:
■ Press one of the two keystone correction buttons on the
projector’s control panel, as shown below. Continue pressing the
button until you are satisfied with the shape of the image.
■ Or press the Menu button on the remote control or projector,
select the
Setting menu, and press Enter.
From the Setting menu, select
Keystone and press Enter. Use
the pointer button on the remote control to adjust the
keystone setting as needed.
If the image quality declines (for example, lines or edges look
jagged), reduce the sharpness setting. See page 101.
tip
You can display a test
pattern to help align the
image (see page 105).