User's Guide
Table Of Contents
- Front Matter
- Contents
- Welcome
- Displaying and Adjusting the Image
- Using the Remote Control
- Connecting to Computers, Cameras, and Other Equipment
- Setting Up Network Projection
- Using Quick Wireless Connection
- Configuring Basic Settings
- Configuring the Connection
- Using Wireless Security Options
- Using the EasyMP Software
- Removing the Wireless 802.11a/b/g Module
- Connecting to a Wired Network
- Using Projector E-mail Alerts
- Using SNMP to Monitor the Projector
- Connecting With Windows Vista
- Fine-Tuning the Projector
- Maintaining the Projector
- Solving Problems
- Projector Installation
- Technical Specifications
- Notices
- Index
16 Displaying and Adjusting the Image
Turning On the Projector
Follow these steps to turn on the projector:
1. Open the A/V Mute slide (lens cover).
2. Plug one end of the power cable into the projector, and the other
end into an electrical outlet.
The P
Power light turns orange.
note
You can set the projector to
automatically turn off the
lamp and enter “sleep mode”
when it has not received any
signals or the A/V Mute slide
remains closed for a period
of time. This conserves
electricity, cools the
projector, and extends the
life of the lamp. To enable
sleep mode, see page 112.
Power light