User's Guide
Table Of Contents
- Front Matter
- Contents
- Welcome
- Displaying and Adjusting the Image
- Using the Remote Control
- Connecting to Computers, Cameras, and Other Equipment
- Setting Up Network Projection
- Using Quick Wireless Connection
- Configuring Basic Settings
- Configuring the Connection
- Using Wireless Security Options
- Using the EasyMP Software
- Removing the Wireless 802.11a/b/g Module
- Connecting to a Wired Network
- Using Projector E-mail Alerts
- Using SNMP to Monitor the Projector
- Connecting With Windows Vista
- Fine-Tuning the Projector
- Maintaining the Projector
- Solving Problems
- Projector Installation
- Technical Specifications
- Notices
- Index
142 Projector Installation
If you’re mounting the projector on the ceiling and you place it above
screen level, you’ll have to tilt the projector down to position the
image on the screen. This causes the image to lose its square shape.
You can correct the distortion using the
Keystone function in the
projector’s menu system (see page 104).
If you place the projector so that the base of the lens is level with the
bottom of the screen, the image should be square and you won’t have
to adjust it. If you place the lens lower than the bottom of the screen,
you’ll have to tilt the projector upward if you want to fill the whole
screen with the image.