User's Guide

112 Fine-Tuning the Projector
■ Operation
Use this menu to enable the following functions:
Direct Power On to have the projector start when the power
cable is connected (without pressing the
PPower button).
Sleep Mode to have the projector turn off automatically if it is
idle (and no signal is received) for the amount of time you select
as the
Sleep Mode Timer (1 to 30 minutes).
Lens Cover Timer to have the projector turn off automatically
after 30 minutes when the A/V Mute slide is closed.
High Altitude Mode to increase cooling when you are using the
projector above 4900 ft (1500 m).
■ Standby Mode
Select Network On to enable the projector to be monitored over
a network when it is in standby mode (the power light is orange).
■ USB Type B
Select USB Display to project your computer’s display through
the projector’s USB Type B port (see page 41). Choose
Link 21L
to use the remote control as a wireless mouse when your computer
is connected to the
Computer (Component Video) port; see
page 42.
■ Link 21L
Enables the projector to work with Link 21L software (not
supported in all regions).
■ Projector ID
Lets you selectively operate two or more projectors in the same
room using one remote control. See page 37 for more
information.
■ Multi-screen
Lets you match the color and brightness levels of two or more
projectors used in the same room. See below for more
information.
■ Language
Select from nine languages to be used for the projector menus.
note
If Direct Power On is
enabled, the power cable is
connected, and a power
outage occurs, the projector
will start when the power is
restored.
Do not use the projector at
altitudes above 7500 ft
(2,286 m).