Installation guide

7
IV. Wiring PixiePlus to Display Device cont’d
V. Reprogram PixiePlus
This section describes how to reprogram the PixiePlus control
codes, which will not be necessary for most installations.
The Projector Controller for Epson is preconfigured with
RS-232 codes that control any compatible Epson projector. The
default codes are:
Button Default Codes
Power ON Power On (RS-232)
Power OFF Power Off (RS-232)
COMP Computer 1/Computer 2 (toggle)
(RS-232)
VIDEO Video (toggle) (RS-232)
AUDIO Epson AP-60 Power Toggle (IR)
BLANK Projector A/V Mute Toggle (RS-232)
VOLUME Up Volume Up (RS-232)
VOLUME Down Volume Down (RS-232)
Programming Overview
The PixiePlus controls AV devices by learning and duplicating
the IR codes of their remote controls. A single button may be
programmed with as many as four codes. Multiple codes may
be sent as macros or round robin.
To program the PixiePlus you will set it to learning mode, arm
each key for IR learning, and squirt it with the appropriate
remote control commands.
Any button may be programmed with any code—it does not
have to be the same as the label silk-screened on the button.
RS-232 Programming
RS-232 commands may be reprogrammed on the PixiePlus
with the SP Controls Programming Wand (PXE-PGM-TOOL).
See Programming Wand documentation for further instructions.
The PXE-DCM+ is a low-voltage device. Never
install the PixiePlus in an electrical back box containing
high-voltage wiring. This would cause serious electrical danger
and violate United States national electrical codes.
7. Once all the connections are made, plug in the PixiePlus
power supply wall wart to the electrical box.