Installation guide

6
Installation Overview
PXE-DCM+
PXE-DCM+ 6VDC
Power Supply
RS-232 Serial Cable
1. Connect the cable assembly (emitter block) to the display via
the serial cable (provided).
2. Connect the IR emitter bud to the display or Epson AP-60.
3. Mount the emitter block to the display using the Velcro
provided.
4. Connect the power block to the nearby ceiling electrical box
(provided by qualified electrician).
5. For use with the AP-60, connect the IR emitter directly to the
AP-60.
6. Mount the PixiePlus to a single-gang wall box (not included)
or the appropriate mounting location. The inner screw holes on
the PixiePlus should be used to anchor the unit to the wall box.
The outer screw holes will be used to affix a Decora™ wall plate
over the face of the PixiePlus.
IV. Wiring PixiePlus to Display Device