Installation guide

I. Introduction
Preconfigured for Easy Setup
The PixiePlus (PXE-DCM+) Projector Controller for Epson®
(ELPSP10) is a single-gang AV control device configured to
provide power, source selection, and volume control of any
compatible Epson projector with RS-232. Users who wish to
control an Epson projector with the Projector Controller’s
preconfiguration may disregard the PixiePlus programming
instructions.
If it is necessary to reprogram the PixiePlus, the modular button
interface and IR device control codes may be easily reconfig-
ured. Modifying the RS-232 commands programmed to each
button requires the SP Controls Programming Wand
(PXE-PGM-TOOL, sold separately).
The PixiePlus may be configured with an Inactivity Shutdown
Timer (pg. 15) to protect bulb life, or with a Security Lock (pg.
16) to prevent unauthorized use. One PixiePlus may be used to
control multiple projectors in tandem with a parallel wired extra
emitter (sold separately).
The PixiePlus may be configured with schedule events (security
lock, auto power off, etc.) at specific times and date ranges
using the PXE-DCM-RTC Real Time Clock Module (not
included). Configuration of schedule events requires the SP
Controls Programming Wand (PXE-PGM-TOOL, sold
separately). See Programming Wand documentation for
schedule configuration instructions.
2
Mounting Screws
Learning Mode
Activation Switch
Status LED
IR Learning
Window
PixiePlus Board
Insert Modules
IR Transmitter