Installation guide

VI. Configuring Special Features cont’d

3. PixiePlus Audio Feedback

By default, the PixiePlus clicks when a button is pressed. To

mute, press and hold any button while inserting a paper clip into

the programming aperture. The PixiePlus will beep quickly three

times to indicate that AUDIO has been set to OFF.

VII. Cloning

Any PixiePlus may quickly and easily copy all the codes from

any other PixiePlus. the PixiePlus cannot clone a Pixie.

In cloning there is a donor unit and a recipient unit. The donor

unit must already be programmed with the appropriate codes

(see Section V). The recipient will copy the donor unit’s codes.

Both units must have the same button insert types, though they

may be different colors.

Both units must be powered. The donor unit should be installed

before beginning.

To power the recipient, you may wish to temporarily

daisy-chain power from the terminal block of the donor

unit with a short length of cable.

Cloning Procedure

1. Set the recipient to cloning mode. If the PixiePlus has never

been programmed, you may set it to cloning mode by pressing

and holding any button while applying power. If a PixiePlus has

previously been programmed, gently insert a paper clip into the

IR lLearning aperture of the recipient unit. Press and hold any

button on that unit and, while still holding the button, remove the

paperclip. The PixiePlus will rapidly chirp while in cloning mode.

approx. one inch apart

facing each other