Installation guide

16
VI. Configuring Special Features cont’d
To change the active setting: Press VOLUME UP or
VOLUME DOWN to cycle to the next setting. The PixiePlus will
indicate the new setting with a pattern of beeps, and update its
Red LED blinking.
When you have reached the desired setting, remove the paper
clip to return to normal operation.
Inactivity Shutdown Timer Settings
PixiePlus Audio PixiePlus Status LED Timer Setting
One long beep LED dark Timer DISABLED*
One quick beep LED blinks once One-hour shutoff
Two quick beeps LED blinks twice Two-hour shutoff
Three quick beeps LED blinks three times Three-hour shutoff
Four quick beeps LED blinks four times Four-hour shutoff
Five quick beeps LED blinks five times Five-hour shutoff
Six quick beeps LED blinks six times Six-hour shutoff
Seven quick beeps LED blinks seven times Seven-hour shutoff
Eight quick beeps LED blinks eight times Eight-hour shutoff
*Default setting
2. Security Keylock
The Security Keylock locks the PixiePlus during disuse to
prevent unauthorized use. It disables the keys on the PixiePlus
after POWER OFF is pressed, until a Security Keycode is
entered on the standard PixiePlus keypad. If the proper code is
not entered, the system cannot be turned on or used.
Use of the Security Keylock feature requires the DISCRETE
POWER ON and POWER OFF keypad module to be inserted.
If your device remote has only a “toggling power” key, you may
still use this module if you program both POWER ON and
POWER OFF with the same (toggle) code.
How the Security Keylock works
When POWER OFF is pressed, the PixiePlus enters a “locked”
state and all keypad buttons go dark.
When the system is locked, any button press other than
POWER ON is understood as a Security Keycode entry. A soft
chirp is emitted, but the key does not illuminate, and no control
operation is performed. If the correct code sequence is entered,
the system unlocks, the interface illuminates, and normal
operation is restored, until the next time POWER OFF is
pushed and the system locks again.