Installation guide

V. Reprogram PixiePlus cont’d

If the button did not seem to learn correctly, press any other

button on the PixiePlus, then press the target button again to

rearm it, and repeat the learning procedure.

8. Repeat for each button: While still in learning mode,

program and verify each button.

9. Set a button to macro mode: If a button has been

programmed with multiple commands, the button may be

configured to send all commands with a single button press. By

default, buttons are configured to Round Robin mode.

After verification, and while still in learning mode, press and

hold the button you wish to set to macro mode for approxi-

mately five seconds. The PixiePlus will beep three times to

indicate that it has now been set to macro mode.

Each button must be independently set to macro mode.

If a button is reprogrammed the code will automatically default

back to round robin mode.

Press-and-hold repeat commands (such as volume ramping)

are not available for buttons set to macro mode. A Macro button

can send one and only one instance of each code with a single

button press. There is a 300 millisecond delay between each

code in the series. Some devices may not be able to respond to

multiple commands sent at this frequency.

10. To control multiple units of the same device: One

PixiePlus may send identical codes to multiple units of the same

device without any additional configuration. For example, you

may control two identical projectors with a single PixiePlus by

adding an additional IR emitter and wiring it from the PixiePlus

to a second projector. A single button press on the PixiePlus will

send identical codes to both devices, and the PixiePlus will

control them in tandem.

11. To control multiple devices: Different buttons on a single

PixiePlus may be programmed with codes from different remote

controls.

Example: You wish to control power and source selection on a

projector, and volume on an IR-controllable amplifier.

To do so, wire one IR emitter to the LCD monitor and the

second IR emitter to the amplifier. Program the PixiePlus power

and source buttons with the codes from the LCD monitor

remote control. Program the PixiePlus volume buttons with the

volume control codes from the amplifier remote control.