Specifications

Specifications Page 67
MESSAGE phase
MESSAGE IN phase
MESSAGE OUT phase
ATTENTION condition
RESET condition
Logic level TTL compatible
Electrical standard ANSI X3T9.2/375R Revision 10L (SCSI 2)
ID Setting Selectable from 0 to 7
Terminator Internal terminator selectable (enable/disable)
Connector type Two 50-pin half pitch connectors (micro DB 50 connectors)
Connector pin
arrangement
Initialization
Methods
The scanner can be initialized (returned to a fixed set of conditions) in the
following ways:
Hardware
initialization
* The scanner is turned on.
* The scanner receives a SCSI Reset signal from the
SCSI interface.
Software
initialization
* Software sends the ESC @ (initialize the scanner)
command.
* The scanner receives a SCSI Bus Device Message.
ref.book Page 67 Monday, September 28, 1998 4:24 PM