Specifications

Troubleshooting Page 49
Scanner Light
The operate light indicates the status of the scanner. If an error occurs,
the scanner stops operating and the operate light shows the type of error.
Light status Scanner status Solution
F (slowly
flashing green)
Initializing or busy scanning —
N (green) Ready to scan images —
O
The scanner is turned off —
F
(rapidly flashing
red)
The interface setup is wrong, or
the scanner is not properly
connected to the computer.
Check the interface connection. Then turn
the scanner off and back on to reset it.
The transportation lock has not
been released, the fluorescent
lamp needs to be replaced, or the
scanner is broken.
Make sure that the transportation lock is in
the unlocked position; then turn the scanner
off and then back on. If the scanner still does
not operate properly, or if this error occurs
repeatedly, consult your dealer.
F
(rapidly flashing
orange)
The cover of the optional auto
document feeder is open, or the
release lever is pressed and
paper feeding unit is slightly open.
Make sure that the cover of the optional auto
document feeder is closed and/or push the
paper feeding mechanism down until it clicks
into place.
No paper is loaded, or paper has
jammed in the auto document
feeder.
Load paper in the auto document feeder, or
turn the scanner off and remove the jammed
paper from the auto document feeder.
N
= on (green),
O
= off,
F
= flashing
ref.book Page 49 Monday, September 28, 1998 4:24 PM