Quick Start Guide

40
THE READY LIGHT
DOESN
’T COME ON…
Check the scanner power
cord.
Make sure the power cord
is securely plugged into
the scanner and the power
outlet, and that the
scanner is turned on.
Also, check that the
power outlet is working.
If you’re using the
optional transparency
unit, make sure the power
adapter is installed
correctly.
IF YOU CAN’T OPEN THE SCANNER DRIVER…
Check the cable connecting the scanner to the
computer.
Make sure the scanner is correctly connected to the
computer. Also, make sure the scanner’s ready light
is on. The scanner must be turned on before you
start your computer. If necessary, turn on your
scanner and restart your computer.
Check your SCSI board installation (PC only).
Make sure that the SCSI interface board is installed
correctly in your computer. See page 8 for details.
Check that your system recognizes your scanner and
SCSI board (PC only).
Check System Device Manager in the Windows
Control Panel, or the Adaptec SCSI Interrogator if
you’re running Windows 3.1. For Windows NT 4.0,
check the SCSI Adapters dialog in the Windows
Control Panel. If your system isn’t recognizing either
the SCSI board or the scanner, go to page 41.
Check for conflicts in your SCSI ID setting, I/O
address, the interrupt setting for your SCSI board,
and other settings.
For information about the SCSI ID setting, see
page 10. For information about choosing other
settings, see your computer manual.
Mint SG 10/27/97, 12:45 PM44