Quick Start Guide

INSTALL THE SCSI INTERFACE BOARD (PC ONLY)

You must install your SCSI board and SCSI software before installing the

scanner driver and software applications.

If you have a Macintosh or if you already have a SCSI board installed in

your PC, skip this section.

Note:

For additional information, see the Installation Guide that came with your

SCSI board.

1. Turn off the computer and any peripheral devices. Unplug any power

cords; then disconnect all cables from the back panel of your computer.

2. Remove the cover from your computer.

Caution:

Ground yourself before you touch any of the computer’s internal components

by touching an unpainted metal surface inside the computer case.

CHOOSE A GOOD PLACE FOR YOUR SCANNER

Here are some points to consider:

◗ Place the scanner on a flat, stable surface. If the scanner is tilted, it can’t

operate properly.

◗ Make sure to place the scanner where you can easily unplug the power

cord, and where the SCSI cable can reach your computer.

◗ Be sure there’s enough room behind the scanner for the cables, and above

the scanner so you can fully raise the document cover, if necessary.

◗ Keep the scanner away from direct sunlight and strong light sources.

◗ Avoid places subject to shocks and vibrations, or high temperatures and

humidity.

Mint SG 10/27/97, 12:25 PM12