Product information guide

EPSON Perfection 600
2 - EPSON Perfection 600
9/97
Environmental Conditions
Note:
Specifications are subject to change without notice.
Interface Specifications
SCSI connector pin assignments:
Changing the Default Settings
You can change default scanning settings before or after you
prescan the image. (This is also true for all advanced scanning
tools and procedures.)
Note:
You can restore the default scan settings at any time by clicking the
Reset button.
You can also change the following settings:
Document Source
To get the best results from your EPSON scanner, you must
specify the type of media you’re scanning.
From the EPSON Perfection 600 main window, select one of
the following document source options:
❏ Reflective—The image is captured when light reflects off
the original on the scanner flatbed. Most originals require
reflective scanning. In the Windows 3.1 scanner driver, this
option is called Flatbed/Reflective.
Temperature: Operation: 41° F to 95° F
(5° C to 35° C)
Storage: –13° F to 140° F
(–25° C to 60° C)
Humidity: Operation: 10% to 80%, without
condensation
Storage: 10% to 85%, without
condensation
Operating
conditions:
Ordinary office or home conditions.
Avoid extremely dusty conditions, direct
sunlight, and strong light conditions
Interface type: ANSI X3T9.2/375D revision 10L
standard
Function: BUS FREE phase
ARBITRATION phase
SELECTION/RESELECTION phase
COMMAND phase
DATA phase
Data in phase
Data out phase
STATUS phase
MESSAGE phase
MESSAGE IN phase
MESSAGE OUT phase
Electrical
standard:
As per ANSI X3T9.2/375D revision 10L
SCSI ID setting: Selectable from 0 to 7 with the rotary
switch (Do not select 8 or 9.) Default
setting is 5.
Connector type: Two 25-pin D-SUB connectors
Terminator type: External 25-pin D-SUB passive
terminator
Signal I/O Pin no. Description
REQ O 1 Request
MSG O 2 Message
I/O O 3 Input/Output
RST I 4 Reset
ACK I 5 Acknowledge
BSY I/O 6 Busy
GND — 7 Ground
DB0 I/O 8 Data Bus 0
GND — 9 Ground
DB3 I/O 10 Data Bus 3
DB5 I/O 11 Data Bus 5
DB6 I/O 12 Data Bus 6
DB7 I/O 13 Data Bus 7
GND — 14 Ground
C/D O 15 Command/Data
GND — 16 Ground
ATN I 17 Attention
GND — 18 Ground
SEL I/O 19 Select
DBP I/O 20 Data Bus P
DB1 I/O 21 Data Bus 1
DB2 I/O 22 Data Bus 2
DB4 I/O 23 Data Bus 4
GND — 24 Ground
TERMPWR — 25 Terminator Power