User`s manual

Section 5: Solving Problems
58 AXIS AX-7 Cobra+ User’s Manual
Error messages
There are four different error conditions that will cause the AX-7
Cobra+ to print an error message on your printer:
This message indicates that the non-volatile memory has been
corrupted. The interface is automatically set to factory default state
(your configuration is lost). If the message does not re-appear after
power-off/power-on, reconfigure the AX-7 Cobra+, see page 14.
The available string area is exhausted. You must remove some strings
from your configuration. (User Definable Strings, String Substitutions
or String parameters in the Parameter List). The size of the available
string area is printed in the Parameter List header, and is also displayed
in all string programming menus.
Incorrect or insufficient bar code definition. The bar code must be
specified with five values. See page 46.
An attempt has been made to enable GDDM (#142) when
insufficient free memory is available. You must remove some strings
from your configuration. (User Definable Strings, String Substitutions
or String parameters in the Parameter List). The size of the available
string area is printed in the Parameter List header, and is also displayed
in all string programming menus.
E2-PERMANENT MEMORY CHECKSUM ERROR, FACTORY DEFAULTS
SET
E6-MEMORY OVERFLOW: FREE STRING AREA EXHAUSTED
BE-BAR CODE ERROR
BF-GDDM SUPPORT NOT ENABLED: NOT ENOUGH ROOM IN FREE
STRING AREA; 13283 ($33E3) BYTES REQUIRED