User`s manual

Section 4: Advanced Functions
AXIS AX-7 Cobra+ User’s Manual 31
Redefine Configuration and Transparency Sequences
The Start and Stop Transparency and Configuration are controlled by
three string parameters:
• Transparency Lead-In Sequence (#070), default ‘%%’.
• Configuration Lead-In Sequence (#071), default ‘%P’
• Transparency/Configuration Trailer Sequence (#072), default ‘%’.
See page 59 for a description of the parameters. The parameters can be
redefined using Configuration from the System, see page 38
Example:
Change the Transparency Lead-In Sequence from ‘%’ to ‘!?<‘ (DBC
codes $19, $18, $09).
Also, change the Trailer Sequence from ‘%’ to ‘>&’ (DBC codes
$08, $30):
❏To redefine the sequences, Extended Emulation Mode must be
entered. The sequences are reset to their default values if you exit
and re-enter Extended Emulation Mode.
❏The sequences are redefined immediately. Therefore, the new
sequences ‘>&’ must be used as Configuration Trailer Sequence
in the document.
%P
(Configuration lead-in sequence)
=40,2
(Set Extended Emulation type 2 permanently)
=70,$19,$18,$09
(Change the transparency lead-in sequence to ‘!?<’)
=72,$08,$30
(Change the configuration trailer sequence to ‘>&’)
=207,10
(Initialize settings)
=207,12
(Save settings permanently)
>&
(Configuration trailer sequence (
new
))