User`s manual
Section 3: Configuration
22 AXIS AX-7 Cobra+ User’s Manual
Select Characters per
Inch (CPI)
This submenu is shown after you have selected LPI.
This is the character spacing of the printout.
The default is 10 Characters per Inch.
The value "Proportional" is used to select proportionally spaced
characters.
‘
Off’ means that no CPI commands are sent to the printer. Use this
selection if you set CPI using the printer’s front panel only.
Select a Character per Inch value.
Note:
❏ The Characters per Inch selection may be overridden by the host
in SCS mode.
End of Configuration
The Basic Configuration is now completed, and the Main Menu is
displayed again.
=====================================================
BASIC CONFIGURATION
=====================================================
CHARACTERS PER INCH
5
_10
12
15
17
Proportional
Off
Use <Up><Down> to move, <Enter> to select