User`s manual

Section 3: Configuration

AXIS AX-7 Cobra+ User’s Manual 21

Select Lines per Inch

(LPI)

This submenu is shown after you have selected Form Length.

This is the line spacing of the printout.

The default is 6 Lines per Inch.

‘

Off’ means that no LPI commands are sent to the printer. Use this

selection if you set LPI using the printer’s front panel only.

Select a Lines per Inch Value

Note:

❏ The Lines per Inch selection may be overridden by the host in

SCS mode.

=====================================================

BASIC CONFIGURATION

=====================================================

LINES PER INCH

Off

Use <Up><Down> to move, <Enter> to select