User`s manual

Section 3: Configuration
14 AXIS AX-7 Cobra+ User’s Manual
Configuration from a Terminal
The AX-7 Cobra+ is equipped with a menu-driven Configuration
Utility. This provides a step-by-step method to adapt the AX-7
Cobra+ to your IBM host and printer. Follow these steps to start the
configuration:
1. Switch off the AX-7 Cobra+. If the power is taken from an
attached printer, then switch the printer off. If you are using an
external power supply, unplug the power cord.
2. Connect a terminal to the AX-7 Cobra+ via a coax cable, and
switch the terminal on.
3. Set the rotary switch in position "0" and switch the AX-7 Cobra+
on. The SYSTEM indicator should now flash rapidly.
Within a few seconds, the Key Definitions Menu should appear on
your terminal.
The rest of Section 3 is a guide to the Configuration Utility. If you
want to restart the configuration, just switch the AX-7 Cobra+ off and
on.