User`s manual

Section 2: Basic Installation
12 AXIS AX-7 Cobra+ User’s Manual
System Attachment
When your AX-7 Cobra+ is configured, and the configuration is
verified by a test printout, it is time to connect it to the IBM system.
1. Switch off the AX-7 Cobra+ by switching off the printer, or, if an
external power supply is used, by unplugging the power cord.
2. Set the rotary switch to position ‘0’ (normal print operation).
3. Connect an IBM coax cable leading from the control unit to the
AX-7 Cobra+.
4. Switch on the AX-7 Cobra+ (switch on the printer or plug in the
external power supply).
The POWER indicator is lit. The SYSTEM indicator flashes for a few
seconds and is then constantly lit.
To verify the attachment, make a local screen copy printout. Use a
terminal attached to the IBM system and send a screen copy print to
the port to which the AX-7 Cobra+ is connected.
You have completed the installation procedure, and your AX-7
Cobra+ is ready for use. It will not need any attendance or service
during normal operation.