User`s manual

Error Messages
"This USB device is not supported."
n Confirm that your camera is a compatible model. The P-6000/7000 can be tethered to certain Nikon
and Canon cameras only.
n Confirm your camera's settings. If your camera has USB settings, select "PTP" or a similar option e.g.
"MTP/PTP". If your camera is not PTP compliant, it is not supported.
"The last connection to camera was terminated abnormally. Some files might not be transferred."
This message is shown at boot up if the viewer is turned off while Tethering is in process. Please check the
images on your memory card and the transferred images.
"Camera has been disconnected. Please connect the Camera again to continue. Are you sure you
want to quit?"
n This confirmation dialogue is displayed when the USB cable is disconnected (when file transfer is not in
process). This message may also be shown when your camera is in sleep mode.
n Connect the camera again to continue. Select Yes to end Tethering. Pressing No will show this dialogue
again.
"Camera has been disconnected while transferring a file. Some files may be lost. Please connect the
Camera again."
n Please connect your camera again. This message is shown when USB cable is disconnected while
transferring a file. In this case, some files may not be transferred.
"Some files may not be transferred because of the unexpected disconnection during this session."
n This message is shown at the end of Tethering if the USB cable was disconnected. In this case, some
files may not be transferred. If you disconnect the USB cable and end Tethering, this message is
shown. To avoid seeing this message, end Tethering before you remove the USB cable.
n If your camera was in Sleep mode and the USB connection was disabled, this message was shown at
the end of Tethering. In this case, the file transfer should complete without problem, and you can
ignore this message.
n If you disconnect camera, shoot images, and connect it again, then the images will not be transferred.
This message informs you that this problem can occur. If you did not disconnect the camera and
viewer, you can ignore this message.
"Connection to Camera is aborted because the remaining free space on HDD is not enough."
n This message is shown if free HDD space becomes less than 512MB. Delete some files on the HDD to
start Tethering again.
Connection
l Cannot be connected: Confirm that your camera is compatible. Make sure that the camera is turned on.
Also, some cameras cannot be connected when in sleep mode. In this case, wake the camera from sleep
mode and connect it again.
l Check the USB cable: Use the USB cable supplied with your camera to connect the camera to the viewer
(and other USB devices).
l Cannot take a picture:
n Confirm your camera's settings: Capturing a picture may not work with particular camera settings.
For example, if the camera is on Focus Prioritizing mode (e.g. AI Focus mode or Focus Mode), the
camera will not take a picture when the image is not focused.