User`s manual

Camera:
l When you connect the camera to the viewer, use the USB cable supplied with your camera.
l Make sure a supported memory card is inserted into the camera. The memory card must have enough free
space. If your camera has multiple memory card slots, use the card in Slot 1.
l The Tethering feature does not guarantee successful file transfer from the camera to P-6000/7000 viewer. As
the viewer will transfer files when the connected camera requests it, the result depends on your camera and
its operation.
l We recommend that you keep your memory card together with transferred images.
P-6000/7000:
l The viewer must have over 512MB free HDD space.
l The viewer may become very hot if you use it whilst it is in the carrying case/pouch. Please take care when
handling the device and ensure you follow the Safety Instructions in the User's Guide. Do not put the viewer
into the carrying case/pouch when using it with the AC adapter.
Setup
Before following the steps below, we recommend connecting the AC adapter to the viewer if possible. Some USB
devices require the viewer to be powered via the AC adapter.
1. Connect the camera to the Host connector on the viewer. Open up the side upper cover and connect a USB
cable to the Host (Standard-A) connector and the other end to the camera.
2. Turn on the viewer and the camera.
3. If your camera has USB settings (Nikon D3X, D3, D300), set the camera's USB mode to MTP/PTP. "Mass
Storage" mode is not supported.
4. Select USB Device on the Home screen using the Up or Down key, then press the Right key.
5. Select Tether to Camera (PTP), then press the OK key to start.
Note:
Do not connect a different USB device to the Slave-Mini B USB interface port at the
same time as using the Host-standard A interface port. It may cause the product to
malfunction.