Service manual

Epson Stylus NX100/105/SX100/105/TX100/101/102/103/105/106/109/ME 300/ME OFFICE 360/NX110/115/SX110/115/TX110/111/112/113/115/117/119 Revision C
DISASSEMBLY/ASSEMBLY Removing the Circuit Boards 72
Confidential
4.4 Removing the Circuit Boards
4.4.1 Panel Unit
 Parts/Components need to be removed in advance:
Scanner Stand/Cover Wire (p 68)
 Removal procedure
1. Open the Scanner Unit.
2. Slide the Panel Unit back with lifting the rear side slightly. And remove the
Panel Unit.
Figure 4-17. Removing the Panel Unit (1)
3. Disconnect the Panel FFC from connector J2 on the Main Board, and remove
the Panel Unit.
Figure 4-18. Removing the Panel Unit (2)
 Disassembling the Panel Unit
 Panel Board
1. Remove the two screws that secure the Panel Board.
2. Release the two hooks, and remove the Panel Board from the Panel Unit.
Figure 4-19. Removing the Panel Board
C H E C K
P O I N T
The disassembly/reassembly procedures for NX110 series differ
from those of NX100 series, see
“ 4.7 Disassembly/reassembly
procedures of NX110 series ” ( p. 108 ) for the procedures.
C A U T I O N
 Be careful when removing the Panel Unit, because the Main
Board and the Panel Board on the rear of the Panel Unit are
connected with the Panel FFC.
 Be careful when carrying out the next procedure, because the
hook on the rear of the Panel Unit is fragile and easily gets
damaged or softened.
 Make sure to work with both hands.
Panel Unit
Middle Housing
Positioning Hole
Hook
C A U T I O N
When disconnecting the Panel FFC from the connector (J2) on the
Main Board, hold the Panel FFC and pull it directly above from
the connector (J2).
Panel Unit
Panel FFC
J2
Panel Board
Positioning Hole
Hook
Panel Unit
SCREW M3x8 P-TITE (5±0.5kgfcm)