Service manual

Epson Stylus NX100/105/SX100/105/TX100/101/102/103/105/106/109/ME 300/ME OFFICE 360/NX110/115/SX110/115/TX110/111/112/113/115/117/119 Revision C
DISASSEMBLY/ASSEMBLY Disassembling the Printer Mechanism 102
Confidential
4.5.14 Waste Ink Pads
 Parts/Components need to be removed in advance:
Scanner Stand/Cover Wire(p 68), Scanner Unit (p 70), Middle Housing (p 71)
Panel Unit (p 72), Main Board (p 73), EJ Roller/ EJ Frame Assy (p 81)
CR Motor/ Driven Pulley (p 83), Ink System (p 85), Main Frame (p 92)
PF Roller (p 98), LD Roller/ ASF Unit (p 99)
 Removal procedure
1. Remove the Waste Ink Pads (A - F) from the Lower Housing.
Figure 4-100. Removing the Waste Ink Pads
Waste Ink Pads (A-F)
Rib
A
B
C
D
Lower Housing
E
 When installing the Waste Ink Pads, align the ribs of the Lower
Housing with the notches of the Waste Ink Pads. (See
Fig.4-100 .)
 When installing the Diffusion Sheet in the section B, install the
Waste Ink Cover and the Waste Ink Pads (x3) in the order
shown below.
Figure 4-101. Installing the Waste Ink Pads (1)
 When installing the Diffusion sheet and the Waste Ink Cover in
the section B, be sure to align their dowels with the positioning
holes of the Lower Housing, then secure them without any gap.
 Install the Waste Ink Pads (x2) in the section C in the order
shown below.
Figure 4-102. Installing the Waste Ink Pads (2)
Diffusion Sheet
Duct Tube End
Parts in section B
1
2
4
5
3
Notch
Dowel
1
2
Notch
Parts in section C