Service manual

73
Set line spacing to n/60 inch
Sets the distance the paper advances or reverses in subsequent line
feeds to n/60 inch, where n is between 0 and 255. If n = 0, the line
spacing is set to 0.
Line feed
Prints the current line and feeds the paper to the next line. See the
preceding commands for the line spacing.
Reverse line feed
Prints the current line and feeds the paper in the reverse direction to
the preceding line.
See the preceding commands for the line spacing.
Select forward feed mode
Cancels the reverse feed mode and selects forward feed mode. This is
the default setting at power-on.
Select reverse feed mode
ASCII Decimal Hexadecimal
<ESC> “A” n 27 65 n 1B 41 n
ASCII Decimal Hexadecimal
<LF> 10 0A
ASCII Decimal Hexadecimal
<ESC> <LF> 27 10 1B 0A
ASCII Decimal Hexadecimal
<FS> “F” 28 70 1C 46
ASCII Decimal Hexadecimal
<FS> “R” 28 82 1C 52
Selects reverse feed mode. Reverses the direction of all vertical
movements. Ignored when friction feed is used.