Service manual

CHARACTER SET COMMANDS

Assign character set

Characters assigned to tables 0 and 1 with this command are not cleared

by the reset command, <ESC> “@”.

Select character table

n2 Character set

0 Italic

1 Code Page #437 U.S.A.

3 Code Page #850 Multi-lingual

7 Code Page #860 Portuguese

8 Code Page #863 Canadian French

9 Code Page #865 Nordic

ASCII Decimal Hexadecimal

27 40 116 3 0 1B 28 74 03 00

n1 n2

<0>

n1 n2

Assigns the chracter set, defind with the value of n2, to the character

table n1 (where n1 is between 0 and 3) as shown below:

n1 Character table

0 Italic

1 Code Page #437 U.S.A.

2 Shift download character area

3 Code Page #437 U.S.A.

ASCII Decimal Hexadecimal

<ESC> “t” n1

27 116

1B 74

Selects a character table defined by the last preceding <ESC> “(” “t”

command.

If there is no preceding <ESC> “(” “t” command, following character

tables are selected.

Select Italic character set

ASCII Decimal Hexadecimal

28 73 0 1C 49 00

Selects the Italic character set. This is the power-up default if EDS

switch D-1 is set to OFF.