Service manual

FONT CONTROL COMMANDS

Select print quality

Changes the print quality according to the value of n, as shown below:

n Print quality

0 Draft

1 Letter quality

Ignored if the FONT LOCK mode was selected during power-up.

Select LQ font

Selects an LQ font according to the value of n. In draft mode, this

command remains dormant and takes effect later when LQ is selected.

Ignored if the FONT LOCK mode was selected during power-up.

n Font

0 Roman

1 Sanserif

2 Courier

3 Prestige

4 Script

ASCII Decimal Hexadecimal

<ESC> “x” n

27 120

1B 78

ASCII Decimal Hexadecimal

<ESC> “k” n

27 107

1B 6B

Select italic characters

ASCII Decimal Hexadecimal

<ESC> “4”

27 52 1B 34

Causes subsequent characters except block graphics to be printed in

italics.