Service manual

59
INTERFACE CONVERTER
To run the printer in serial mode, you should use the optional Serial/Parallel
Converter, SPC-8K.
The procedure to install the Converter is:
1. Set the DIP switches on the SPC-8K before attaching it to the pritner.
(See next page for detailed information.)
2. Turn off the power switch and disconnect the power cord from the power
source.
3. Disconnect the interface cable if attached.
4. Connect the Parallel connector to the printer.
5. Move both clips inside the extended prongs on the sides of the plug until
you hear a click.
Figure 7-11. Connect the Parallel connector to the printer.
6. Connect the Serial connector to your computer.
NOTE: Place the Converter on a table in order not to damage the cable.
Figure 7-12. Place the converter on a table.